by Phil Kerner | Nov 24, 2013 | Members Only: The Tool Room, Surface Grinding
While I did a short video "tip" on this a few months ago. I decided to take the time to record a full-length video of the entire process from start to finish. I did take the liberty to "fast forward" some of the video as there was really no sense in watching the table...
by Phil Kerner | Nov 10, 2013 | Members Only: The Tool Room, Surface Grinding
In this week's video, we pick right up where we left off last week in the grinding room. This is another long one - about 45 minutes - and of course things didn't go quite to plan. But again, some terrific teaching points. At the end of this video, you'll notice I...
by Phil Kerner | Nov 4, 2013 | Members Only: The Tool Room, Surface Grinding
Because I kind of left off with my grinding class due to the frustration of having to have to try and film myself, I thought it might be best if I gently walked my subscribers back to the beginning. So, here's my thoughts on when it's time to fire up the surface...
by Phil Kerner | Nov 4, 2013 | Members Only: The Tool Room, Surface Grinding
In this video, we'll take a short walk around a basic manual 6 x 12 surface grinder and kick the tires. The "6 x 12" number refers to the size of the magnetic chuck on the table and is the way all grinders of this type are described. They're usually referred to as...
by Phil Kerner | Nov 4, 2013 | Members Only: The Tool Room, Surface Grinding
There's so much going on in this video that I had to record a video just to explain what you're about to learn:
