7 For 7: October 2012

Breaking Taps? Here's How I Stopped The Curse

After over 35 years of being in the trade, I have to say that nothing is more demoralizing than having a piece just about finished and then SNAP - breaking a tap in the piece. Obviously, I'm talking about "power tapping" here as you have to work pretty hard to break a tap when you're hand-tapping.

Depending on the size, getting a broken tap removed without the benefit of an EDM machine is a time-consuming chore and usually bungs up the threads in the process.

The good news is that - knock on wood - I haven't broken a tap in over a year and that's after tapping literally thousands of holes.

I actually experimented a lot with this process as I knew I had to figure it out because I am, after all, The Tool & Die Guy.

Here's my secrets:


How To Check Your Work Using Your Digital Readout and a Dial Indicator

Sometimes, it's imperative to be able to measure a dimension while the part is still on the machine and still set up. Removing the part for measurement checking means that you'll have to re-check everything after you put it back in...the most accurate way to get things done right is to check your work while it's still clamped in place and to make your adjustments based on "real time" measurements. Here's a trick I use almost every day to check my work using a dial indicator and the digital readout on my machine:


The "C" Washer - A Great Time Saver

Here's a little trick I use several times a week and especially when I have more than one part to machine. Removing clamps and replacing them on each part is time consuming...here's how to cut your set-up time down by 70%:


How To Indicate a Hole in Less Than a Minute

People at work are always shocked by how fast I can "pick up" on a hole...here's how I do it every single day. Just practice it, it's like learning a golf swing. Repetition is the key...you'll get more confident by doing it over and over. Do this drill for an hour and you'll have it down pat, guaranteed.


Vise Stops For Beginners

Whenever you have more than one part to do, you HAVE to use some kind of a "stop" to locate your work or you're just wasting your time. A vise stop is really just a very simple fixture that lets you keep loading parts into the same exact position every single time. Here are the ones I use, and a short explanation of how to load your work against them.


The Most Versatile "Stop" That I Own

In addition to the "stops" the the video above, here's one that I don't use a lot but is an absolute life-saver when you need a "stop" to get out of the way of your machining. Confused? You won't be after this video:


How to Measure The Location of a Hole Using Micrometers: The Right Way

In this case study, I have been handed a part with a hole already bored into it, and need to mill an edge to a certain dimension in relation to the hole. As we have already learned, I would prefer to measure this part "as is" in the vise and NOT remove it. I've decided to use  a set of micrometers, and here's how to do it correctly: